Refer to the CertainTeed ProFin^® Data and Submittal sheets for specific product technical information.

Refer to the CertainTeed ProFin^® Technical and Data sheets for recommended jobsite conditions and preparation of gypsum board surfaces.

All of these documents are available at our website (www.bpb-na.com) or from your local CertainTeed sales representative.

Site Conditions
The room temperature should be maintained at 55°F/13°C for 48 hours prior to application and continuously thereafter until completely dry. Gypsum wallboard should be dry for at least 48 hours before the application of texture products. Continuous ventilation must be provided to ensure proper drying. When using temporary heating, care should be taken to avoid overheating and high humidity.

Warranty
Since methods and condition of application such as temperature, humidity and over thinning are beyond our control, CertainTeed Gypsum, Inc. (CertainTeed) will not be responsible for the failure of this product when not used according to directions and specifications and accepted standards of procedure inherent in drywall application; or when reasonable allowance is not made by the user for adverse weather and job conditions. However, if this product proves to be defective, maximum liability shall be limited to replacement of the material only or refund of the purchase price. This shall be the full limit whatsoever of CertainTeed’s liability. All claims shall be submitted in writing to CertainTeed within thirty days from the date of discovery. State or federal laws may provide rights in addition to this warranty that cannot be modified or excluded.